Tech Support Forums - TechIMO.com - View Single Post

kopfjaeger · February 21st, 2007, 12:33 AM

Hello Dan,

No I have not done either. I'll have to give that a shot. Actually, I thought I'd had that covered by checking out the manual and setting the DIP switches in the following manner:

1-4 set as a multiplier of 8

5-8 set FSB at 100 == for a CPU that was 800 Mhz

DIP's 9-10 had to be set for manual configuration, rather than done by the software in BIOS setup.

I have some PC133 memory that I can try, do you think by resetting the CMOS jumper and using a PC133 module, that it might at least give me some power and images on the screen?

Thanks. Good thing I didn't toss the board just yet.

KJ

February 21st, 2007, 12:33 AM	#3 (permalink)
kopfjaeger Member Join Date: Jul 2003 Posts: 320	Hello Dan, No I have not done either. I'll have to give that a shot. Actually, I thought I'd had that covered by checking out the manual and setting the DIP switches in the following manner: 1-4 set as a multiplier of 8 5-8 set FSB at 100 == for a CPU that was 800 Mhz DIP's 9-10 had to be set for manual configuration, rather than done by the software in BIOS setup. I have some PC133 memory that I can try, do you think by resetting the CMOS jumper and using a PC133 module, that it might at least give me some power and images on the screen? Thanks. Good thing I didn't toss the board just yet. KJ __________________ This is supposed to be a joyous occasion -- let's not bicker over who killed who.