how to display mac-port table in 3com switch?

[yaniv]

Hi everyone,
I have an organizational 3 com switch, model 3CR17562-91.

I'm trying to see what mac addresses use what physical ports.
i have read the guide, it should be very simple by entering the cli interface of the device and typing:
display mac-address

but everytime i do so, i get an "unrecognized command" error.
can someone help me with this issue?

thanks a a lot, Yaniv.

[Boog400]

Router# show mac address table

that should pull up the table for the switch. make sure you are in the right mode too (privileged exec.)

[map7000]

You should be at privilege level 3 to use this command
Try
<#>super 3
<#>display mac-address
2 Boog400 It's CISCO command. It would not work on 3Com