Can't ping between interfaces...ASA 5510

[sender4u]

Problem solved.

[nemowolf]

interface Ethernet0/0
nameif inside
security-level 100
ip address 192.168.0.254 255.255.255.0
!
interface Ethernet0/1
nameif outside
security-level 0
ip address THIS SHOULD ALL BE XXXd OUT. 255.255.255.0
!
interface Ethernet0/2
nameif DMZ
security-level 50
ip address 10.10.10.1 255.255.255.0
!
interface Management0/0
nameif management
security-level 90
ip address 192.168.1.1 255.255.255.0
management-only

That is the only pertinent peice of info needed here. Now I am going to assume you are not a networking person because you put the ENTIRE config of your ASA on here. Bad practice there. You might want to trim out all your stuff down to the min like i did.

Second thing is that you probably need to get a lesson on subnetting and general networking. With the way your IP schemes are setup, nothing should be able to talk to each other because they are all on seperate IP's. All of your subnets are set to only talk to the same ###.###.###.X IP addresses, you might want to find out WHY you need seperate interfaces and if they need to talk amongst themselves anywats. For instance, why have a seperate interface for management if all its really just part of the inside interface.

Im not really all that familiar with Cisco equipment as my exposure is really limited but im just seeing that you have it setup to keep everything very seperated. Depending on how you have your individual ports setup, you could be running into more problems.

[sender4u]

Thanks for the reply

The reason I did put the entire config here is that I want people to see NAT and default routes…there is no wrong putting your private IP’s here because NAT is there.

Yes you are right I don’t want any of my interfaces to talk to each other without a static route.

You probably have not seen the title of this post Can't ping between interfaces...ASA

and ASA is a CISCO product and I was expecting a reply from someone who knows about it.

By the way none of my addresses are subnetted. So you need to revise you networking.

[nemowolf]

Thanks for the reply

The reason I did put the entire config here is that I want people to see NAT and default routes…there is no wrong putting your private IP’s here because NAT is there.

Yes you are right I don’t want any of my interfaces to talk to each other without a static route.

You probably have not seen the title of this post Can't ping between interfaces...ASA

and ASA is a CISCO product and I was expecting a reply from someone who knows about it.

By the way none of my addresses are subnetted. So you need to revise you networking.

I am actually so offended at your response ... I can only ...

PS: I hope your support contract with Cisco is up to date.