SBS 2003 can't connect to internet after CEICW

[GiganticDays]

SBS2003 Premium with ISA Server2004

The above has been running fine for a couple of years. Up til now we never had a domain name but recently set one up (1and1 are the host). Previously all remote access was done using our fixed IP address.

We have pointed the domain to our IP address and all seemed to be fine (haven't set up a website yet but RWW/OWA etc were accessible using the domain name).

After a couple of other unrelated changes we ran CEICW and now can't connect to the internet at all, nor does RWW work.

I think what may have caused the problem is a recently acquired wireless AP which was connected when we ran CEICW. It was detected as a router and we were asked if we wanted the wizard to configure it - yes we said (without thinking), and off it went.

In an attempt to fix this I removed the AP altogether and re-ran CEICW but it still didn't help.

I suspect the default gateway address is incorrect (it should be the IP of the router yes?). I can't access the router's configuration page using what I though was it's IP so I'm stumped.

Anyone help?

[GroundZero3]

What default gateway does the network card have right now? Normally in a smaller environment its the router address (depending on how you have this all configured)

[Nude_Lewd_Man]

I'm just about to leave work, but one point to remember is that RWW will only enable you to RDP to machines that use port :3389 (the default RDP port) for connections...

Will check back later.

[GiganticDays]

Looks like this was a combination of two things; the buggering up of the configuration and a failing router/modem.

I've replaced the modem, re-run CEICW and all is well again. Even managed to get the iPhones connecting remotely

Thanks for the input

[Nude_Lewd_Man]

Glad to hear (read) that it is working for you...