Draytek Vigor 2600 setup problems

**james73** · October 29th, 2003, 01:05 PM

We've just bought the Draytek for our small office network
to replace the frog modem we got from our ISP. Our
network is on the 192.168.0.xxx IP addresses on subnet
255.255.255.0

When I connect the Draytek to our network, be it either an
underfloor cable, a remote switch, or the main switch, I cannot
reach the Draytek on 192.168.1.1 and the set-up CD fails to
connect to it - "Failed to load settings."

On the device itself, I'm connecting the RJ-45 cable to the 'P1'
socket and the green light next to it stays on, but the 'Act' (activity)
light keeps blinking.

I'm new to routers (and even to LAN's :-/ ) but I thought this would
be easy to setup. Anyone offer any suggestions as to what I'm
doing wrong?

TIA.

James H

**meese** · October 29th, 2003, 03:43 PM

How does your LAN get IP addresses? Do you have a DHCP server? If you do you will need to disable the DHCP server built into the router. Also are you sure no other devices on your LAN are using 192.168.1.1 already?

EDIT:

Wait a minute. You say your lan is using 192.168.0.1, but the router is 192.168.1.1. These are two different subnets. You need to change the ip address of the router to 192.168.0.1. I order to do this you may need to remove a pc from you lan and connect it to the router. At this point the router will assign this pc an ip address in the 192.168.1.x range. You should be able to access the router setup now from this pc. Change the router ip address to 192.168.0.1 and save the configuration. Now stick the router back in with the lan and reconnect the other pc to your lan. Now it should work.

**james73** · October 29th, 2003, 04:01 PM

Yep, got it going now. I changed one PC's IP address
to 192.168.1.xxx, accessed the router, changed its
IP to 192.168.0.xxx, changed the PC back, and I can
configure it now.