Thread: SVGA/VGA Pin configuration
October 21st, 2005, 07:03 PM #1
SVGA/VGA Pin configuration
I recently purchhased a Samsung 204T 20.1 inch monitor. The supplied VGA cord was too short to reach to my computer. I needed about two more feet. I ordered a high quality SVGA cable on line. When it arrived I discovered that pin number 9 is missing. The original monitor cable had all 15 pins. Is it safe to use this new cable on my monitor? I found out that many VGA/SVGA cables do not have a number 9 pin. But I don't know when the number 9 pin is required.
Is my new monitor safe with this new cable?
October 21st, 2005, 07:50 PM #2
Should be fine. If it don't work, it won't work.
October 21st, 2005, 08:10 PM #3
- Join Date
- Aug 2003
- Madison, WI
- Blog Entries
Yea, it is fine, most cables don't have a #9 pin."The problem with quotations on the internet is that the sources are hard to verify" - Abraham Lincoln
October 22nd, 2005, 02:07 PM #4
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By bill1971 in forum PC HardwareReplies: 5Last Post: December 16th, 2012, 12:53 PM
By _Switch_ in forum PC HardwareReplies: 2Last Post: May 28th, 2005, 02:20 PM
By geosca in forum PC HardwareReplies: 12Last Post: August 7th, 2003, 03:55 AM
By massacres in forum General Tech DiscussionReplies: 3Last Post: May 15th, 2003, 10:30 PM
By desmocat in forum PC HardwareReplies: 20Last Post: October 18th, 2002, 11:29 AM