+ Reply to Thread
Results 1 to 3 of 3
Thread: New Epox board will not boot
November 10th, 2005, 08:45 PM #1
New Epox board will not boot
Hello everyone, I got a new motherboard to replace my dead motherboard.
Its the Epox EP-8RDA-PRO. It gives me an error while posting- F2. I can't really understand the manual, so I have no idea what it is.
I get power to everything, its a Post error. So, I think I can rule out the PSU.
AMD Athlon XP 2600+ [had to use stock cooler]
1,024 MB of RAM
Sony DVD Burner
Hard Drive WD 160 GB [Not connected]
November 10th, 2005, 09:41 PM #2
I guess it was a memory problem. Removed 1 stick, it booted fine to BIOS.
November 10th, 2005, 10:19 PM #3
I got both sticks to work, I put them in different colored slots.
Unfortunately, when I turned on my PC, I hit my finger in a fan that had a wire rubbing on the base. That SOB cut me bad. Ouch!!
Well, tomorrow I will install Windows. Wish me luck.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By alibibassman in forum PC HardwareReplies: 10Last Post: July 22nd, 2003, 05:44 PM
By Benssax in forum PC HardwareReplies: 4Last Post: January 22nd, 2003, 05:52 PM
By iNeb in forum PC HardwareReplies: 14Last Post: January 17th, 2003, 03:20 PM
By Eladijaz in forum PC HardwareReplies: 15Last Post: December 6th, 2002, 10:14 AM
By fyxxer32 in forum PC HardwareReplies: 4Last Post: October 3rd, 2002, 08:41 PM