problem with custom computer

[Milwaukee]

I got all new computer it
Intel Pentuim D 820
512 mb ddr2
WD Sata 80 GB
ESC motherboard http://www.newegg.com/Product/Produc...82E16813135023

It will turn on and I see monitors show gray screen but when on or off it shake so I try set but not success. I want use VGA instead graphic card.

I try different rams, reset cmos, remove battery but not success.
I think it must be motherboard must be bad but it turn on but won't show on monitors.

I want use this by tomorrow.

[caveminder]

with onboard vga you change setting in the bios setup from agp or pci-e to onboard and plug monitor into vga port.

[Milwaukee]

Fix it. I didn't see 4 pin near to CPU was another power plug so it was different because most I work on old motherboards. Now it boot up then install window xp home

[Rootstonian]

Different thread, but you were there too...sometimes people just don't spend 5 minutes searching this wonderful forum for advice

Computer turns on but does not boot